Difference between revisions of "Rebuild v1.0.0"
From iagent
| Line 1: | Line 1: | ||
[[File:Rebuild header.png|center]] | [[File:Rebuild header.png|center]] | ||
| − | |||
| − | |||
| − | |||
Rebuild is a complete Linux image for Recore 3D printer controller boards. It comes with Klipper installed and the choice of either MainSail, Fluidd or OctoPrint. | Rebuild is a complete Linux image for Recore 3D printer controller boards. It comes with Klipper installed and the choice of either MainSail, Fluidd or OctoPrint. | ||
Revision as of 12:10, 23 March 2024
Rebuild is a complete Linux image for Recore 3D printer controller boards. It comes with Klipper installed and the choice of either MainSail, Fluidd or OctoPrint.
Rebuild is still in testing There is a release candidate available: v1.0.0-RC1
Installing an image
For instructions on making a flasher image, have a look at Reflash
Note
In order to install Rebuild v1.0.0-RC1, you need to use Reflash v1.0.0-RC0 or newer.
Latest images
The latest images for Recore are available from github: https://github.com/intelligent-agent/Rebuild/releases, but you can also choose to install an image directly from Reflash.
KlipperScreen is running on X, so a new config should allow rotating the screen.
sudo nano /usr/share/X11/xorg.conf.d/90-monitor.conf
Add the following:
Section "Monitor"
Identifier "HDMI-1"
Option "Rotate" "left"
EndSection
After that, KlipperScreen can be restarted.
sudo systemctl restart KlipperScreen