Difference between revisions of "Remote A1"

Revision as of 21:56, 2 May 2024

[mcu remote]
serial: /dev/serial/by-id/usb-Klipper_rp2040_E661AC8863905924-if00

[static_digital_output remote_led]
pins: remote:gpio2

[output_pin fan_r_1]
pin: remote:gpio1

[output_pin fan_r_2]
pin: remote:gpio12

[output_pin fan_r_3]
pin: remote:gpio21

[tmc2209 extruder3]
uart_pin: remote:gpio7
uart_address: 0
run_current: 0.500
hold_current: 0.500
sense_resistor: 0.1
stealthchop_threshold: 250

#endstop_pin: remote:gpio4
#enable_pin: !remote:gpio10
#rotation_distance: 40
#microsteps: 16
#position_endstop: 0
#position_max: 200
#homing_speed: 20.0

[extruder3]
step_pin: remote:gpio6
dir_pin: remote:gpio5
heater_pin: remote:gpio0
sensor_type: EPCOS 100K B57560G104F
sensor_pin: remote:gpio28
rotation_distance: 40
microsteps: 16
nozzle_diameter: 0.400
filament_diameter: 1.75
control: pid
pid_Kp: 22.2
pid_Ki: 1.08
pid_Kd: 114
min_extrude_temp: 30
min_temp: -272
max_temp: 300

[verify_heater extruder3]
check_gain_time: 2400

[adc_temperature remote_fan_current_0]
temperature1: 0
voltage1: 0
temperature2: 33
voltage2: 3.3

[temperature_sensor remote_fan_current_0]
adc_voltage: 3.3
sensor_pin: remote:gpio29
sensor_type: remote_fan_current_0
max_temp: 2.0
gcode_id: RemoteFanCurrent0

[adxl345]
cs_pin: remote:gpio25
spi_bus: spi1c

[resonance_tester]
accel_chip: adxl345
probe_points:
    100, 100, 20  # an example
    
[probe]
pin: remote:gpio22
#--------------------------------------------------------------------
x_offset: 0
y_offset: 25.0
z_offset: 0	
speed: 10.0
samples: 3
samples_result: median
sample_retract_dist: 3.0
samples_tolerance: 0.01
samples_tolerance_retries: 3

# Set this high to use GPIO20 as high frequency input
[static_digital_output Relit_direction]
pins: !remote:gpio19

[neopixel relit]
pin: remote:gpio20
chain_count: 12


[fan peltier]
pin: remote:gpio3
max_power: 0.1
cycle_time: 0.00001 #0.01
hardware_pwm: True
@@ Line 1: / Line 1: @@
+<div class="res-img">
 [[File:Remote A1.png]]
+</div>
 <pre>
 [mcu remote]