Difference between revisions of "Redeem"
From iagent
(Replaced content with "center Redeem architecture <br> Redeem settings<br> Redeem g-codes<br> Redeem m-codes<br>") (Tag: Replaced) |
|||
| (2 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
[[File:Redeem.png|center]] | [[File:Redeem.png|center]] | ||
| + | Redeem is the firmware that controls Replicape and Revolve. It's similar to other 3D-printer firmwares in that it translates G-code into synchronous stepper movements and maintains temperatures. | ||
| + | The software can be found in the redeem repository: https://github.com/intelligent-agent/redeem | ||
| + | |||
| + | This page is an overview of the configuration and architecture of Redeem. All pages here is related to the configuration and use of Redeem. You will typically not install Redeem directly, but instead use the version that comes with [[Umikaze]]. | ||
| + | <br> | ||
[[Redeem architecture]] <br> | [[Redeem architecture]] <br> | ||
[[Redeem settings]]<br> | [[Redeem settings]]<br> | ||
[[Redeem g-codes]]<br> | [[Redeem g-codes]]<br> | ||
[[Redeem m-codes]]<br> | [[Redeem m-codes]]<br> | ||
Latest revision as of 15:21, 20 October 2018
Redeem is the firmware that controls Replicape and Revolve. It's similar to other 3D-printer firmwares in that it translates G-code into synchronous stepper movements and maintains temperatures.
The software can be found in the redeem repository: https://github.com/intelligent-agent/redeem
This page is an overview of the configuration and architecture of Redeem. All pages here is related to the configuration and use of Redeem. You will typically not install Redeem directly, but instead use the version that comes with Umikaze.
Redeem architecture
Redeem settings
Redeem g-codes
Redeem m-codes