Difference between revisions of "Getting started"
From iagent
| Line 2: | Line 2: | ||
# Wire up your 3D printer to the [[Replicape_Rev_B | Replicape]] or [[Recore]]. | # Wire up your 3D printer to the [[Replicape_Rev_B | Replicape]] or [[Recore]]. | ||
# Install [[Refactor]] on the BeagleBone Black or Recore. | # Install [[Refactor]] on the BeagleBone Black or Recore. | ||
| − | + | #* Recore comes with Refactor pre-installed. | |
| − | + | #* For Replicape, Refactor needs to be installed. | |
# Connect to the device [[Connecting]]. | # Connect to the device [[Connecting]]. | ||
# Adjust the [[Klipper_settings]] for your 3D printer. | # Adjust the [[Klipper_settings]] for your 3D printer. | ||
Revision as of 08:18, 26 July 2021
How do I get started?
- Wire up your 3D printer to the Replicape or Recore.
- Install Refactor on the BeagleBone Black or Recore.
- Recore comes with Refactor pre-installed.
- For Replicape, Refactor needs to be installed.
- Connect to the device Connecting.
- Adjust the Klipper_settings for your 3D printer.