Difference between revisions of "Remove A0"
From iagent
| Line 1: | Line 1: | ||
Remove is an accellerometer for doing input shaping with Klipper. | Remove is an accellerometer for doing input shaping with Klipper. | ||
| + | Klipper configuration: | ||
<pre> | <pre> | ||
| + | # The Remove resonance tester mcu | ||
| + | [mcu rp2040] | ||
| + | serial: /dev/ttyACM0 | ||
| + | baud: 1500000 | ||
[adxl345] | [adxl345] | ||
| Line 11: | Line 16: | ||
probe_points: | probe_points: | ||
100, 100, 20 # an example | 100, 100, 20 # an example | ||
| − | |||
</pre> | </pre> | ||
Revision as of 21:17, 29 August 2022
Remove is an accellerometer for doing input shaping with Klipper.
Klipper configuration:
# The Remove resonance tester mcu
[mcu rp2040]
serial: /dev/ttyACM0
baud: 1500000
[adxl345]
cs_pin: rp2040:gpio5
spi_bus: spi0a
[resonance_tester]
accel_chip: adxl345
probe_points:
100, 100, 20 # an example