Remove A0: Difference between revisions
From iagent
Created page with "Remove is an accellerometer for doing input shaping with Klipper." |
No edit summary |
||
| (3 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
Remove is an accellerometer for doing input shaping with Klipper. | Remove is an accellerometer for doing input shaping with Klipper. | ||
<div class="res-img"> | |||
[[File:Remove A0 iso.jpg|center]] | |||
</div> | |||
Klipper configuration: | |||
<pre> | |||
# The Remove resonance tester mcu | |||
[mcu rp2040] | |||
serial: /dev/ttyACM0 | |||
baud: 1500000 | |||
[adxl345] | |||
cs_pin: rp2040:gpio5 | |||
spi_bus: spi0a | |||
[resonance_tester] | |||
accel_chip: adxl345 | |||
probe_points: | |||
100, 100, 20 # an example | |||
</pre> | |||
Latest revision as of 21:59, 8 September 2022
Remove is an accellerometer for doing input shaping with Klipper.
Klipper configuration:
# The Remove resonance tester mcu
[mcu rp2040]
serial: /dev/ttyACM0
baud: 1500000
[adxl345]
cs_pin: rp2040:gpio5
spi_bus: spi0a
[resonance_tester]
accel_chip: adxl345
probe_points:
100, 100, 20 # an example