Difference between revisions of "Renits A5"
From iagent
(Created page with "Renits is an HDMI screen with touch capabilities. ===Firmware upgrade=== In order to perform a firmware upgrade, the screen must first enter bootsel mode. This can be done...") |
(→Firmware upgrade) |
||
| Line 1: | Line 1: | ||
Renits is an HDMI screen with touch capabilities. | Renits is an HDMI screen with touch capabilities. | ||
| + | |||
| + | ===Adjusting brightness=== | ||
| + | The brightness can be adjusted by pressing the "+" and "-" keys on the back of the board. | ||
| + | Alternatively, the brightness can be set via the commandline. | ||
| + | To set the brightness to full: | ||
| + | <pre> | ||
| + | brightness 100 | ||
| + | </pre> | ||
===Firmware upgrade=== | ===Firmware upgrade=== | ||
Revision as of 22:21, 27 November 2024
Renits is an HDMI screen with touch capabilities.
Adjusting brightness
The brightness can be adjusted by pressing the "+" and "-" keys on the back of the board. Alternatively, the brightness can be set via the commandline. To set the brightness to full:
brightness 100
Firmware upgrade
In order to perform a firmware upgrade, the screen must first enter bootsel mode. This can be done by holding in both keys on the back of the board when applying power. Alternatively, the bootloader can be entered via the command line for the screen.
minicom -o -D /dev/ttyACM0
Once communication with the screen has been established, the bootloader can be started with the command
bootsel