Getting started: Difference between revisions
From iagent
No edit summary |
No edit summary |
||
| Line 2: | Line 2: | ||
# Wire up your 3D printer to the [[Replicape_Rev_B | Replicape]] or [[Recore]]. | # Wire up your 3D printer to the [[Replicape_Rev_B | Replicape]] or [[Recore]]. | ||
# Install [[Refactor]] on the BeagleBone Black or Recore. | # Install [[Refactor]] on the BeagleBone Black or Recore. | ||
- Recore comes with Refactor pre-installed. | |||
- For Replicape, Refactor needs to be installed. | |||
# Connect to the device [[Connecting]]. | # Connect to the device [[Connecting]]. | ||
# Adjust the [[Klipper_settings]] for your 3D printer. | # Adjust the [[Klipper_settings]] for your 3D printer. | ||
Revision as of 08:15, 26 July 2021
How do I get started?
- Wire up your 3D printer to the Replicape or Recore.
- Install Refactor on the BeagleBone Black or Recore.
- Recore comes with Refactor pre-installed. - For Replicape, Refactor needs to be installed.
- Connect to the device Connecting.
- Adjust the Klipper_settings for your 3D printer.