Difference between revisions of "Remove A1"
From iagent
| Line 9: | Line 9: | ||
</div> | </div> | ||
| − | Klipper configuration | + | === Klipper configuration === |
<pre> | <pre> | ||
# The Remove resonance tester mcu | # The Remove resonance tester mcu | ||
| Line 24: | Line 24: | ||
probe_points: | probe_points: | ||
100, 100, 20 # an example | 100, 100, 20 # an example | ||
| + | |||
| + | [static_digital_output remove_leds] | ||
| + | pins: rp2040:gpio17, rp2040:gpio18 | ||
| + | |||
</pre> | </pre> | ||
Revision as of 22:02, 23 September 2022
Remove is an accellerometer for doing input shaping with Klipper.
Pinout diagram
Klipper configuration
# The Remove resonance tester mcu
[mcu rp2040]
serial: /dev/ttyACM0
baud: 1500000
[adxl345]
cs_pin: rp2040:gpio5
spi_bus: spi0a
[resonance_tester]
accel_chip: adxl345
probe_points:
100, 100, 20 # an example
[static_digital_output remove_leds]
pins: rp2040:gpio17, rp2040:gpio18