Revolt A1: Difference between revisions
From iagent
No edit summary |
No edit summary |
||
| Line 5: | Line 5: | ||
Klipper config | ==Klipper config== | ||
<pre> | <pre> | ||
[tmc5160 stepper_x] | [tmc5160 stepper_x] | ||
| Line 23: | Line 23: | ||
sense_resistor: 0.05 | sense_resistor: 0.05 | ||
cs_pin: ar100:PD0 | cs_pin: ar100:PD0 | ||
chain_position: 2 | chain_position: 2 | ||
chain_length: 2 | chain_length: 2 | ||
</pre> | </pre> | ||
Revision as of 15:16, 9 September 2023
Revolt is a dual 48 V compatible stepper motor driver add-on board. It is based on TMC5160.
Klipper config
[tmc5160 stepper_x] run_current: 0.8 hold_current: 0.5 sense_resistor: 0.05 cs_pin: ar100:PD0 spi_software_sclk_pin: ar100:PD2 spi_software_mosi_pin: ar100:PD1 spi_software_miso_pin: ar100:PD3 chain_position: 1 chain_length: 2 [tmc5160 stepper_y] run_current: 0.8 hold_current: 0.5 sense_resistor: 0.05 cs_pin: ar100:PD0 chain_position: 2 chain_length: 2