Difference between revisions of "Redeem"
From iagent
| Line 1: | Line 1: | ||
[[File:Redeem.png|center]] | [[File:Redeem.png|center]] | ||
| − | Redeem is the firmware that controls Replicape and Revolve. It's similar to other 3D-printer firmwares in that it translates G-code into synchronous stepper movements and maintains temperatures. | + | Redeem is the firmware that controls Replicape and Revolve. It's similar to other 3D-printer firmwares in that it translates G-code into synchronous stepper movements and maintains temperatures. This page is an overview of the configuration and architecture of Redeem. <br> |
[[Redeem architecture]] <br> | [[Redeem architecture]] <br> | ||
[[Redeem settings]]<br> | [[Redeem settings]]<br> | ||
[[Redeem g-codes]]<br> | [[Redeem g-codes]]<br> | ||
[[Redeem m-codes]]<br> | [[Redeem m-codes]]<br> | ||
Revision as of 14:42, 20 October 2018
Redeem is the firmware that controls Replicape and Revolve. It's similar to other 3D-printer firmwares in that it translates G-code into synchronous stepper movements and maintains temperatures. This page is an overview of the configuration and architecture of Redeem.
Redeem architecture
Redeem settings
Redeem g-codes
Redeem m-codes