Difference between revisions of "Remove A0"
From iagent
| Line 1: | Line 1: | ||
Remove is an accellerometer for doing input shaping with Klipper. | Remove is an accellerometer for doing input shaping with Klipper. | ||
| − | + | [[File:Remove A0 iso.jpg|center]] | |
Klipper configuration: | Klipper configuration: | ||
<pre> | <pre> | ||
Revision as of 21:58, 8 September 2022
Remove is an accellerometer for doing input shaping with Klipper.
Klipper configuration:
# The Remove resonance tester mcu
[mcu rp2040]
serial: /dev/ttyACM0
baud: 1500000
[adxl345]
cs_pin: rp2040:gpio5
spi_bus: spi0a
[resonance_tester]
accel_chip: adxl345
probe_points:
100, 100, 20 # an example