Revolt A1: Difference between revisions
From iagent
No edit summary |
No edit summary |
||
| Line 4: | Line 4: | ||
</div> | </div> | ||
Klipper config | |||
<pre> | <pre> | ||
[tmc5160 stepper_x] | |||
run_current: 0.8 | |||
hold_current: 0.5 | |||
sense_resistor: 0.05 | |||
cs_pin: ar100:PD0 | |||
spi_software_sclk_pin: ar100:PD2 | |||
spi_software_mosi_pin: ar100:PD1 | |||
spi_software_miso_pin: ar100:PD3 | |||
chain_position: 1 | |||
chain_length: 2 | |||
[tmc5160 stepper_y] | |||
run_current: 0.8 | |||
hold_current: 0.5 | |||
sense_resistor: 0.05 | |||
cs_pin: ar100:PD0 | |||
#spi_software_sclk_pin: ar100:PD2 | |||
#spi_software_mosi_pin: ar100:PD1 | |||
#spi_software_miso_pin: ar100:PD3 | |||
chain_position: 2 | |||
chain_length: 2 | |||
</pre> | </pre> | ||
Revision as of 15:15, 9 September 2023
Revolt is a dual 48 V compatible stepper motor driver add-on board. It is based on TMC5160.
Klipper config
[tmc5160 stepper_x] run_current: 0.8 hold_current: 0.5 sense_resistor: 0.05 cs_pin: ar100:PD0 spi_software_sclk_pin: ar100:PD2 spi_software_mosi_pin: ar100:PD1 spi_software_miso_pin: ar100:PD3 chain_position: 1 chain_length: 2 [tmc5160 stepper_y] run_current: 0.8 hold_current: 0.5 sense_resistor: 0.05 cs_pin: ar100:PD0 #spi_software_sclk_pin: ar100:PD2 #spi_software_mosi_pin: ar100:PD1 #spi_software_miso_pin: ar100:PD3 chain_position: 2 chain_length: 2