Remote A1

[mcu remote] serial: /dev/serial/by-id/usb-Klipper_rp2040_E661AC8863905924-if00

[static_digital_output remote_led] pins: remote:gpio2

[output_pin fan_r_1] pin: remote:gpio1

[output_pin fan_r_2] pin: remote:gpio12

[output_pin fan_r_3] pin: remote:gpio21

[tmc2209 extruder3] uart_pin: remote:gpio7 uart_address: 0 run_current: 0.500 hold_current: 0.500 sense_resistor: 0.1 stealthchop_threshold: 250

1. endstop_pin: remote:gpio4
2. enable_pin: !remote:gpio10
3. rotation_distance: 40
4. microsteps: 16
5. position_endstop: 0
6. position_max: 200
7. homing_speed: 20.0

[extruder3] step_pin: remote:gpio6 dir_pin: remote:gpio5 heater_pin: remote:gpio0 sensor_type: EPCOS 100K B57560G104F sensor_pin: remote:gpio28 rotation_distance: 40 microsteps: 16 nozzle_diameter: 0.400 filament_diameter: 1.75 control: pid pid_Kp: 22.2 pid_Ki: 1.08 pid_Kd: 114 min_extrude_temp: 30 min_temp: -272 max_temp: 300

[verify_heater extruder3] check_gain_time: 2400

[adc_temperature remote_fan_current_0] temperature1: 0 voltage1: 0 temperature2: 33 voltage2: 3.3

[temperature_sensor remote_fan_current_0] adc_voltage: 3.3 sensor_pin: remote:gpio29 sensor_type: remote_fan_current_0 max_temp: 2.0 gcode_id: RemoteFanCurrent0

[adxl345] cs_pin: remote:gpio25 spi_bus: spi1c

[resonance_tester] accel_chip: adxl345 probe_points:

   100, 100, 20  # an example
   

[probe] pin: remote:gpio22

1. --------------------------------------------------------------------

x_offset: 0 y_offset: 25.0 z_offset: 0 speed: 10.0 samples: 3 samples_result: median sample_retract_dist: 3.0 samples_tolerance: 0.01 samples_tolerance_retries: 3

1. Set this high to use GPIO20 as high frequency input

[static_digital_output Relit_direction] pins: !remote:gpio19

[neopixel relit] pin: remote:gpio20 chain_count: 12

[fan peltier] pin: remote:gpio3 max_power: 0.1 cycle_time: 0.00001 #0.01 hardware_pwm: True