Umikaze uses Octoprint for interacting with the Replicape and your 3D printer.
To access, go to kamikaze.local
If you cannot connect, read the section on :doc:`/support/howto/linklocal`.
Once you connect to the OctoPrint interface, you will need to step through setup the first time. As you step through the setup:
- Set a username and password for OctoPrint
- It's recommended that you keep Access Control Enabled for security reasons.
- Set your print bed dimensions
- Axis speeds can be left at the defaults, as they only control the manual movements that you make through OctoPrint.
Sometimes it is necessary to make changes to the configurations directly or to debug a broken config file without going through the OctoPrint browser interface. For those unfamiliar with working with a linux operating system, check out our :doc:`/support/howto/beginlinux`.
Connecting via Network 17:42, 20 October 2018 (CEST)17:42, 20 October 2018 (CEST)17:42, 20 October 2018 (CEST)17:42, 20 October 2018 (CEST)~~
For the standard Beaglebone Black connected via ethernet.
Useful terminal commands
Starts a log within the terminal
sudo journalctl -fl
Opens network control panel
Restarts Redeem. Can also be done from OctoPrint
sudo systemctl restart redeem
Shows which version of Kamikaze is installed
Show the status of Toggle
systemctl status toggle -l -n 100
Connecting via USB
For BeagleBone Black Wireless, network access isn't yet established.
To determine the device's name once attached look at the output of
ls -al /dev/cu.usbmodem* before and then
after you connect your host computer to the device. Next attach to the serial console:
screen /dev/cu.usbmodem<number> 115200
minicom -o -D /dev/cu.usbmodem<number> 115200
There are two user accounts that have admin permissions:
If you are not on a secure or private network, it is highly recommended to :ref:`change the password <ChangePassword>` for both accounts. Someone accessing your device can intentionally (or unintentionally) damage your 3D printer.
These user passwords are completely separated from the octoprint users you setup during the setup wizard for access control.