Difference between revisions of "Getting started"
From iagent
(→How do I get started?) |
|||
(3 intermediate revisions by the same user not shown) | |||
Line 1: | Line 1: | ||
==How do I get started?== | ==How do I get started?== | ||
− | # Wire up your 3D printer to the [[Replicape_Rev_B | Replicape]] or [[ | + | # Wire up your 3D printer to the [[Replicape_Rev_B | Replicape]] or [[Recore_A6]]. |
− | # Install [[ | + | # Install [[Refactor]] on the BeagleBone Black or Recore. |
+ | #* Recore comes with Refactor pre-installed. | ||
+ | #* For Replicape, Refactor needs to be installed. | ||
# Connect to the device [[Connecting]]. | # Connect to the device [[Connecting]]. | ||
− | # Adjust the [[ | + | # Adjust the [[Klipper_settings]] for your 3D printer. |
Latest revision as of 00:57, 23 January 2022
How do I get started?
- Wire up your 3D printer to the Replicape or Recore_A6.
- Install Refactor on the BeagleBone Black or Recore.
- Recore comes with Refactor pre-installed.
- For Replicape, Refactor needs to be installed.
- Connect to the device Connecting.
- Adjust the Klipper_settings for your 3D printer.