Difference between revisions of "Getting started"
From iagent
(→How do I get started?) |
|||
| Line 1: | Line 1: | ||
==How do I get started?== | ==How do I get started?== | ||
| − | # Wire up your 3D printer to the [[Replicape_Rev_B | Replicape]] or [[ | + | # Wire up your 3D printer to the [[Replicape_Rev_B | Replicape]] or [[Recore]]. |
| − | # Install [[ | + | # Install [[Refactor]] on the BeagleBone Black or Recore. |
# Connect to the device [[Connecting]]. | # Connect to the device [[Connecting]]. | ||
| − | # Adjust the [[ | + | # Adjust the [[Klipper_settings]] for your 3D printer. |
Revision as of 15:04, 1 May 2021
How do I get started?
- Wire up your 3D printer to the Replicape or Recore.
- Install Refactor on the BeagleBone Black or Recore.
- Connect to the device Connecting.
- Adjust the Klipper_settings for your 3D printer.