Difference between revisions of "Main Page"
From iagent
| Line 8: | Line 8: | ||
{| class="mediawiki" style="width: 100%; vertical-align:top;" | {| class="mediawiki" style="width: 100%; vertical-align:top;" | ||
|style="vertical-align:top;"| | |style="vertical-align:top;"| | ||
| − | == | + | |
| − | * [[ | + | == Hardware == |
| − | + | * [[Recore A6]] | |
| − | * [[ | + | * [[Manga Screen 2]] |
| − | + | * [[Replicape Rev B]] | |
| − | + | ||
| − | |||
| − | * [[ | ||
| − | |||
| − | |||
| − | |||
|style="vertical-align:top;"| | |style="vertical-align:top;"| | ||
| Line 24: | Line 19: | ||
* [[Refactor]] Complete Linux distribution for 3D-printers | * [[Refactor]] Complete Linux distribution for 3D-printers | ||
* [[Toggle]] The software for Manga Screen | * [[Toggle]] The software for Manga Screen | ||
| − | |||
| − | |||
| − | |||
|style="vertical-align:top;"| | |style="vertical-align:top;"| | ||
| − | == | + | ==HowTo== |
| − | * [[ | + | * [[Getting started]] |
| − | * [[ | + | * [[Connecting | Connecting to the board]] |
| − | * [[ | + | * [[Printer_101 | Printer 101]] |
| + | * [[FAQ]] | ||
| + | |- | ||
| + | |style="vertical-align:top;"| | ||
====Old hardware==== | ====Old hardware==== | ||
* [[Revolve]] (Cancelled) | * [[Revolve]] (Cancelled) | ||
| Line 39: | Line 34: | ||
* [[Replicape Rev A]] | * [[Replicape Rev A]] | ||
* [[Manga Screen 1]] | * [[Manga Screen 1]] | ||
| + | |style="vertical-align:top;"| | ||
| + | ====Off site==== | ||
| + | * [https://www.klipper3d.org/ Klipper] The "firmware" for Replicape/Recore | ||
| + | * [https://octoprint.org/ OctoPrint ] The software for controlling the printer. | ||
| + | |style="vertical-align:top;"| | ||
| + | ====Guides==== | ||
| + | * [[BLTouch | Using BLTouch with Replicape]] | ||
| + | * [[Adding a Servo | Adding a Servo to Replicape]] | ||
| + | * [[Adding a Probe for G29/G33]] | ||
| + | * [[Cartesian | Cartesian configuration guide]] | ||
| + | * [[Corexy | CoreXY configuration guide]] | ||
|- | |- | ||
| − | |||
|style="vertical-align:top;"| | |style="vertical-align:top;"| | ||
Revision as of 21:16, 22 January 2022
This is the documentation for Recore, Manga Screen 1 and 2, Refactor and Toggle hardware and software products developed by made by Intelligent Agent. All software is free and open source. Recore is open schematic hardware and can be conveniently purchased in the store.
ContentsHardware |
Software |
HowTo |
Old hardware
|
Off site |
Guides |
Development |
Contributing |
Legacy Information |