Difference between revisions of "Rebuild"
From iagent
(4 intermediate revisions by the same user not shown) | |||
Line 1: | Line 1: | ||
− | Rebuild is a | + | [[File:Rebuild header.png|center]] |
+ | Rebuild is a complete Linux image for Recore 3D printer controller boards. It comes with Klipper installed and the choice of either MainSail, Fluidd or OctoPrint. | ||
+ | |||
+ | Rebuild is still in testing There is a release candidate available: v1.0.0-RC1 | ||
+ | |||
+ | =Installing an image= | ||
+ | For instructions on making a flasher image, have a look at [[Reflash]] | ||
+ | <div class="alert alert-warning"> | ||
+ | ===='''Note'''==== | ||
+ | In order to install Rebuild v1.0.0-RC1, you need to use Reflash v1.0.0-RC0 or newer. | ||
+ | </div> | ||
+ | |||
+ | =Latest images= | ||
+ | The latest images for Recore are available from github: https://github.com/intelligent-agent/Rebuild/releases, but you can also choose to install an image directly from Reflash. | ||
− | |||
− | |||
KlipperScreen is running on X, so a new config should allow rotating the screen. | KlipperScreen is running on X, so a new config should allow rotating the screen. | ||
Line 19: | Line 30: | ||
sudo systemctl restart KlipperScreen | sudo systemctl restart KlipperScreen | ||
</pre> | </pre> | ||
− |
Revision as of 12:10, 23 March 2024
Rebuild is a complete Linux image for Recore 3D printer controller boards. It comes with Klipper installed and the choice of either MainSail, Fluidd or OctoPrint.
Rebuild is still in testing There is a release candidate available: v1.0.0-RC1
Installing an image
For instructions on making a flasher image, have a look at Reflash
Note
In order to install Rebuild v1.0.0-RC1, you need to use Reflash v1.0.0-RC0 or newer.
Latest images
The latest images for Recore are available from github: https://github.com/intelligent-agent/Rebuild/releases, but you can also choose to install an image directly from Reflash.
KlipperScreen is running on X, so a new config should allow rotating the screen.
sudo nano /usr/share/X11/xorg.conf.d/90-monitor.conf
Add the following:
Section "Monitor" Identifier "HDMI-1" Option "Rotate" "left" EndSection
After that, KlipperScreen can be restarted.
sudo systemctl restart KlipperScreen