Difference between revisions of "Restep A1"
| Line 2: | Line 2: | ||
<div class="res-img"> | <div class="res-img"> | ||
[[File:Restep A1 front.jpg]] | [[File:Restep A1 front.jpg]] | ||
| + | </div> | ||
| + | |||
| + | |||
| + | ==== Pinout diagram ==== | ||
| + | <div class="res-img"> | ||
| + | [[File:Restep A1 pinout.png|center]] | ||
</div> | </div> | ||
Revision as of 22:27, 23 September 2022
Restep is an add-on board for Recore A6 which gives it an extra TMC2209 stepper driver. This is great if you want to build a 3D-printer with 7 motors, like the Voron 2.4.
Pinout diagram
Mounting it on Recore
Restep should be mounted so the stepper is pointing upwards and the 6 pin header is pointing down. The 6 pin female header goes into the header on the board marked S6 or S7.
Choosing address
If you only have one Restep board mounted on Recore, you do not have to alter it in any way. The default UART address will then be 3. If you want to add one more board, you can cut the lines on AD0 which will give the board address 2. Address 0 and 1 are reserved for stepper 4 and 5 which are mounted on the board on UART3(pins PD0/PD1).
Klipper Configuration
In this example, the X-axis is routed to S7. Only the relevant changes are shown.
[tmc2209 stepper_x] uart_pin: ar100:PD1 tx_pin: ar100:PD0 uart_address: 3 [stepper_x] step_pin: ar100:PL11 dir_pin: ar100:PE15