Difference between revisions of "Getting started"
From iagent
| Line 1: | Line 1: | ||
==How do I get started?== | ==How do I get started?== | ||
| − | # Wire up your 3D printer to the [[Replicape_Rev_B | Replicape]] or [[ | + | # Wire up your 3D printer to the [[Replicape_Rev_B | Replicape]] or [[Recore_A6]]. |
# Install [[Refactor]] on the BeagleBone Black or Recore. | # Install [[Refactor]] on the BeagleBone Black or Recore. | ||
#* Recore comes with Refactor pre-installed. | #* Recore comes with Refactor pre-installed. | ||
Revision as of 00:57, 23 January 2022
How do I get started?
- Wire up your 3D printer to the Replicape or Recore_A6.
- Install Refactor on the BeagleBone Black or Recore.
- Recore comes with Refactor pre-installed.
- For Replicape, Refactor needs to be installed.
- Connect to the device Connecting.
- Adjust the Klipper_settings for your 3D printer.