Difference between revisions of "Restep A1"

From iagent
Jump to: navigation, search
(Choosing address)
(Klipper Configuration Recore A5 and A6)
Line 35: Line 35:
  
 
=== Klipper Configuration Recore A5 and A6 ===
 
=== Klipper Configuration Recore A5 and A6 ===
In this example, the X-axis is routed to S7. Only the relevant changes are shown.  
+
In this example, the X-axis is routed to S6. Only the relevant changes are shown.  
 
<pre>
 
<pre>
 
[tmc2209 stepper_x]
 
[tmc2209 stepper_x]

Revision as of 11:07, 31 January 2024

Restep is an add-on board for Recore A6 and Recore A7 which gives it an extra TMC2209 stepper driver. This is great if you want to build a 3D-printer with 7 motors, like the Voron 2.4.

Restep A1 front.jpg


Pinout diagram

Restep A1 pinout.png

Mounting it on Recore

Restep should be mounted so the stepper is pointing upwards and the 6 pin header is pointing down. The 6 pin female header goes into the header on the board marked S6 or S7.

Choosing address

Note

It is only necessary to change the address if you are going to use two Resteps on a Recore A6

If you only have one Restep board mounted on Recore, you do not have to alter it in any way. The default UART address will then be 3. If you want to add one more board, you can cut the lines on AD0 which will give the board address 2. Address 0 and 1 are reserved for stepper 4 and 5 which are mounted on the board on UART3(pins PD0/PD1).

Klipper Configuration Recore A7

In this example, the X-axis is routed to S6. Only the relevant changes are shown.

[tmc2209 stepper_x]
uart_pin: ar100:PD2
uart_address: 3

# Route stepper X to header S6
[stepper_x]
step_pin: ar100:PL10
dir_pin: ar100:PE14

Klipper Configuration Recore A5 and A6

In this example, the X-axis is routed to S6. Only the relevant changes are shown.

[tmc2209 stepper_x]
uart_pin: ar100:PD1
uart_address: 3

# Route stepper X to header S6
[stepper_x]
step_pin: ar100:PL10
dir_pin: ar100:PE14