Main Page: Difference between revisions

Revision as of 20:24, 13 October 2018

This is the documentation for Revolve, Manga Screen, Redeem and Toggle hardware and software products developed by made by Intelligent Agent. All software is free and open source. Revolve is also open source hardware, but can be conveniently purchased in the store.

HowTo

Software

Umikaze Edgy Ubuntu BBB image for 3D-printers
Kamikaze Stable Debian BBB image for 3D-printers
Redeem: The "firmware" for Replicape *new*
Toggle The "software" for Manga Screen
OctoPrint The software for controlling the printer.
CuraEngine The slicer installed on Kamikaze.
G-Code Reference *new*
M-Code Reference *new*
T-Code Reference *new*

Hardware

Development

Legacy Information

Older pages on this wiki
Replicape Rev A
Manga Screen
Replicape and Kamikaze/Umikaze: Getting Started
What are all these options in Redeem for???
Redeem The "firmware" for Replicape
Pinouts
Replicape rev B
Setting up Replicape for Cartesians (In the works!)
Setting up Replicape for CoreXY
Setting up Replicape for Deltas

@@ Line 2: / Line 2: @@
 [[File:Delta+H.jpg|frameless|1000px|center]]
-This is the documentation for Revolve, Manga Screen, Redeem and Toggle hardware and software products developed by made by Intelligent Agent. All software is free and open source. Revolve is also open source, but can be conveniently purchased in the store.
+This is the documentation for Revolve, Manga Screen, Redeem and Toggle hardware and software products developed by made by Intelligent Agent. All software is free and open source. Revolve is also open source hardware, but can be conveniently purchased in the store.
 __NOTOC__