Main Page
<img src="http://www.thing-printer.com/mediawiki/images/wiki_header.png" width="100%">
Thing printer is a development platform for electronics and software made by Intelligent Agent. All software is
free and open source. The hardware is also open source, but can be conveniently purchased in the store.
This is the thing wiki. It has a lot of info about Replicape, Manga Screen, Redeem, Kamikaze and Reach.
NEW DOCUMENTATION!
Completed reorganized! Updated getting started guide. Wiring diagram and specs. And ability for different versions of the documentation!
Replicape Documentation
(for replicape and redeem only)
And anyone can contribute! Check out How To Contribute
HowTo
Software
- Umikaze Edgy Ubuntu BBB image for 3D-printers
- Kamikaze Stable Debian BBB image for 3D-printers
- Redeem: The "firmware" for Replicape *new*
- Toggle The "software" for Manga Screen
- OctoPrint The software for controlling the printer.
- CuraEngine The slicer installed on Kamikaze.
- G-Code Reference *new*
- M-Code Reference *new*
- T-Code Reference *new*
Legacy Information
- Older pages on this wiki
- Replicape Rev A
- Manga Screen
- Replicape and Kamikaze/Umikaze: Getting Started
- What are all these options in Redeem for???
- Redeem The "firmware" for Replicape
- Pinouts
- Replicape rev B
- Setting up Replicape for Cartesians (In the works!)
- Setting up Replicape for CoreXY
- Setting up Replicape for Deltas
MediaWiki has been installed.
Consult the User's Guide for information on using the wiki software.